Single & Double Door Installation Manual 1
Safety Warnings and Cautions IMPORTANT: Bronco Hardware cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings and cautions in this manual are not all inclusive. Use care and good judgment in the installation and operation of the hardware and door(s). Always take precautions to protect yourself and others. Follow all applicable national, state, local, and industry-specific safety regulations and standards.
Package Includes Front-Mounted Roller/Door Hanger: Use to hang the door up Sliding Track: Door slides on the track Spacer: Place it between the sliding track and wall Lag Bolts with Anchor: Go through the spacer into the wall as the supporter Door Stopper: Stop the door falling off the track Floor Guides + Anti Jump Pads: Help guiding the door in a straight line and prevents door jump off the track Track Connector: Need it if track size is above 90in (7.
Step 0. (If your track is 7.5FT or under, please skip this step) Connect the tracks with the track connector like the above diagram. Align the holes on the track connector with two small holes at the end of the track. Tighten the screws and nuts. Step 1. Use a stud finder to locate the drywall studs and mark them up. Hold the track up and align with the marked studs to make sure the holes on the track match the studs on the wall. You can also mount a header-board into the studs first.
Step 2. Measure the height of the door and apply the formula above to draw a horizontal line that is same length as the track. The line has to be level. Next, you can hold the track up to align with the horizontal line to make sure the line is at the center of the pre-drilled holes of the track. Step 3. Use a drill with 11/64” drill bit and then drill holes on the marks.
Step 4. Insert a lag bolt with a washer and then go through the track to a spacer just like the above picture. Then, line up with the holes that you drilled previously. Lastly, tighten the bolts with 1/2’’ hand wrench/power socket ranch. Repeat the steps for the remaining holes. Step 5. Cut a slot underneath the door for 1/4” wide and 1” deep by using a router. This is use for fit in the floor guide. If you are not comfortable cutting the groove or do not have a router, please visit broncohardwareshop.
Step 6. Drill the holes like the above diagram for the door hanger/roller. The distance from the top of the door to the center of the first hole is 1 5/8”. The distance from the side door edge and the roller is at your personal preference. However, it should be at least 1” away from the door edge to prevent any damage to your door. Lastly, install the hex bolts and the nuts just like in the diagram above. If you purchased the black wheel door hanger, the measurement are the same. Step 7.
Step 8. Carry the door near the track and lift the door up with angle so that the door hanger/roller are over the track. Lower the door so the groove in the roller are sitting on the track. Step 9. Put the door stopper at a desired position and tighten the screw on the door stopper with hex wrench included in the bag with door stopper.
Step 10. 1. Slide the door to the side so the door way is cleared. 2. Position the floor guide at the centered in the channel. 3. Mark the center holes of the floor guide and put it aside. 4. Take a drill with 7/32” drill bit and drill the holes that you marked. 5. Insert the plastic anchors into the holes and then position the floor guide with the holes. Finally, insert the screw and tighten the screw with a Philips screwdriver.
