Installation Manual

www.bromicheating.com

ELEMENT INSTALLATION

1. Remove the front cover from the heater.

2. Check that ring terminals are crimped securely to

cables. 2000W & 3000W models have one cable

at each end for assembly of one element. 4000W

& 6000W models have two cables at each end for

assembly of two elements. The first element must

be connected to the cables marked L1 & N1. The

second element must be connected to the cable

marked L2 & N2.

3. Fasten elements to cables. Remove outer nut &

lock washer from the threaded stud on the element.

Assemble ring terminal to the threaded stud &

secure with outer nut and lock washer. Use one

spanner to hold the inner nut on the element, while

fastening the outer nut with a second spanner.

Repeat for other end of element.

4. Put elements in the support bracket. For 2000W &

3000W models put element in the centre position.

For 4000W & 6000W models put elements in the

outside positions.

WARNING

This Heater MUST be permanently Installed and hard

wired by an authorised/licenced person. Do Not perform

maintenance, or carry out installation or assembly

procedure while electrical power is switched on.

2000W & 3000W Models 4000W & 6000W Models