User's Manual

Instant Wireless - Network USB Adapter User Manual
7
Section 2 - Hardware Installation
This chapter covers connecting your Instant Wireless - Network USB Adapter to
USB port of desktop or notebook PC, and connecting the Adapter to a network.
2.1 Connecting the USB Adapter
Follow the procedure below to install the Adapter.
1. Connect one end of USB cable into the Adapter.
2. Connect the other end of USB cable to USB port on desktop or notebook PC.
2.2 Status LEDs
The following table describes the meaning of the LEDs:
LED MEANING
PWR Indicates that the Card is powered on.
ACT Indicates link status. It is normally blinking.
When blinking, indicates that the card is
scanning the channels, and the link is not
active. When lit, indicates that the card is
locked to a channel, and the link is active.
2.3 Remove the USB Adapter
For the Adapter supports Hot Swapping feature. With this feature, you can
remove and reconnect the Adapter whenever you want.