User's Manual

Instant Wireless - Network USB Adapter User Manual
23
they are not running. In case a communication has been established, the
configuration parameters of the adapter can be changed on the fly by using the
Configuration and Monitor Application described in the section Configuration
and Monitor Application.
After you have installed the Adapter, you can easily change its configuration
through the Control Panel (Start -> Settings -> Control Panel), where you select
the Network icon and then the Instant Wireless - Network USB Adapter card in
the Configuration tab.
With the Instant Wireless - Network USB Adapter card highlighted press the
Properties button or double-click on the higlighted icon in order to configure the
Adapter. In the new window, select the Advanced tab and adjust the operational
parameters of the card. This tab is the same with the one that appeared during
the installation (Figure 3-1). Please check the paragraph Installing the Driver
Under Windows ME for details about the configuration parameters.
Please note that in order for any change in these parameters to take effect, the
computer must be restarted. Windows will prompt you to restart the computer.
5.5 Uninstall Procedures Under Windows ME
In order to uninstall the Adapter from Windows ME, you must double click on the
Network option in the Control Panel (Start -> Settings -> Control Panel). Select
the Instant Wireless - Network USB Adapter card from the list and press the
Remove button. The system will prompt you to re-boot. Press Yes to re-boot.