User's Manual

Preface
iii
This device is intended only for OEM integrators under the fol-
lowing conditions:
1) The antenna must be installed such that 20 cm is maintained be-
tween the antenna and users, and
2) The transmitter module may not be co-located with any other
transmitter or antenna.
As long as 2 conditions above are met, further transmitter
test will
not be required. However, the OEM integrator is still responsible
for testing their end-product for any additional compliance re-
quirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not
be met (for example certain laptop configurations or co-location
with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not
be used on the final
product. In these circumstances, the OEM integrator will be re-
sponsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where
the antenna may be installed such that 20 cm may be maintained
between the antenna and users (for example access points, routers,
wireless ADSL modems, and similar equipment). The final end
product must be labeled in a visible area with the following: “Con-
tains TX FCC ID: O6M-WM253”.