User's Manual

11Mbps Wireless Access Point User's Manual
25
The IP Addr Tab
IP ADDR: displays the status of current IP setting .
IP Address Mode: SelectStatic” or “DHCP” mode. For “Static mode, the IP
address settings are given by user. For “DHCP” mode, these
settings will be overridden by a DHCP server on your network.
IP Address: The static IP address you want to assign to the AP. The default value is
192.168.1.100”.
IP Subnet: The subnet mask you want to assign for the AP. The default value is
255.255.255.0”.
IP Gateway: The gateway you want to assign for the AP. The default value is
192.168.1.1”.
Allow upgrade uploads: Uncheck the box, then the AP can be allowed to firmware
upgraded.
Note!
After reboot, you need to re-load the page to see any new settings.