User's Manual

User Manual of Wireless Access Point with 4-Port 10/100M LAN Switch
7
2.Hardware Installation
Physical Details
Rear Panel
Front Panel
The front panel features four 10/100Mbps Ethernet ports. These LAN ports are used to
connect to your computers or other network devices.
4-port 10/100Mbps LAN connection RESET Button
DC Power Input LED indications
Power Input Only use the power adapter supplied with the Access Point
LAN Connection Use standard Ethernet cables (RJ-45 connector) to connect your
PC, hub/switch or broadband router/modem to this port.
INIT Button “INIT” mean “Initiation”. While pressing the button, the AP will
reboot and reset current settings to factory default settings. The left
indicator “DIAG” on AP will be off and then begin blinking. Then this
initiation action will be completed when the indicator “ DIAG” is
always green instead of blinking.
Diversity Dipole Antenna