User Manual

USB Wireless Network Adapter User’s Manual

Configuring the USB Wireless Network Adapter

1. This screen shows you the status of your current connection.

2. Select the “Configuration” tab. The profile setting allows you to save

configurations in different profiles for different working environments. The default

profile will contain the initial configuration setting when you install the Card. Under

the Wireless Mode drop-box, you may choose either Infrastructure or Ad-Hoc. The

Infrastructure mode allows a wireless adapter to communicate with a wired network

employing an Access Point, while the Ad-Hoc mode allows wireless-to-wireless,

peer-to-peer communication. If you choose Infrastructure, the SSID should have

the same name as the Access Point. If you choose Ad-Hoc, all clients should share

the same SSID name. You may also select which Transfer Rate you wish to use: 1,

2, 5.5, 11Mbps or Auto Rate. Under Power Saving Mode, you can select

Enabled to allow your adapter to go to sleep mode while the adapter doesn’t

proceed the data transmission. Or select Disabled to make the adapter never go to

sleep mode. Click Apply to save the settings.