Troubleshooting guide

13
C.2 Lighting Procedures (Cont.)
MANUAL IGNITION - MAIN CHAMBER
1
Press and hold the LOWER PILOT BUTTON (a).
Use match or long-stemmed lighter to light
PILOT
TUBES (b)
. Light the pilot closest to the feed end of
the broiler. After pilot has lit, hold pilot button for 30
seconds, release and verify that lower burners have
lit. Repeat for the
UPPER PILOT BUTTON (c).
2
After releasing red pilot buttons; check GAS
PRESSURE GAUGE (a) reading. Gauge should read
4”. If not, follow troubleshooting tips in section E of
this manual. Verify that main chamber burners -
upper and lower - have lit.
a
b
a
c
MANUAL IGNITION - FLEX CHAMBER
1
Remove the UPPER GREASE PAN (not pictured -
see DISASSEMBLY). Press and hold the PILOT
BUTTON (a)
and place the long stemmed lighter or
match on the PILOT BURNER (b) located on the
outboard (manifold) side of the flex chamber. After
pilot is lit, hold pilot button for 30 seconds and
release.
2
After releasing pilot button, verify that LOWER
BURNERS have lit and that the GAS PRESSURE
GAUGE
reads 4” (a).
a
b
a
LOWER BURNER
Nieco Corporation - Model 9025
LIGHTER/MATCH
PILOT
LIGHTER/MATCH