Datasheet

1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before installing.
1. Place the connector of the cable in the hole on the side of the holder. Carefully press the connector downward
and forward so it passes the locking and goes into the hole. Press until you hear/feel the connector snap into
place in the holder.
2. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back.
Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws.
Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the
holder is firmly in place, but still can be adjusted. To place the device in the holder: Place the lower part of the
device in the holder.
3. Flip/press the upper part forwards so it snaps into place in the holder. Carefully, slide the device sideways into
the holder so you hear/feel it snaps into place. To remove the device from the holder: Slide it to the left. Press
upwards on the upper part of the holder, in the same time pull the upper part of the device out from the holder
and lift the device up and out from the holder.
4. The holder is in place.
2(2)