Specifications

587 Tilt Wheelchair
32
2. From the above instructions, determine whether you want to wind the stem further into
the actuator or further out of the actuator. You will need to wind the stem further into the
actuator if the chair is not tilting (wind it clockwise) and wind it further out of the actuator if
the chair is slowly sliding out of position. (wind it counter clockwise)
3. Check the function of the cylinder and repeat steps 3 & 4 until the cylinder functions
properly.
4. Tighten the lock nut loosened in step 1.
Removing and Installing the Cylinders
1. Remove the 5/16” mounting bolt from the end of the cylinder (requires 2 x 1/2”
wrenches).
2. Loosen the lock nut located on the stem of the cylinder by the actuator.
3. Wind the stem of the cylinder out of the actuator.
4. Wind the stem of the new cylinder into the actuator.
5. Reinstall the 5/16” mounting bolt.
6. Adjust the cylinder as per the above adjustment instructions.
5.6 Vinyl Straps
Maintenance
The only maintenance required for the vinyl strapping is general cleaning with an ammonia or
chlorine based cleaner (Do not use petroleum based cleaners).
Diagram #23
Vinyl Strap