Specifications

587 Tilt Wheelchair
28
6. Hook the end of the cable into the lever in the actuator and clip the cable housing into the
actuator housing.
5.4 Rear Wheels
Removing and Installing the Rear Mag Wheels
1. Remove hubcap from wheel by turning counter clock-wise by hand
2. Using a 5/8” combination wrench, loosen hex screw and locknut at axle of wheel
3. To install, reverse steps 1-2.
Ensure that the head of the bolt is towards the inside and the nut is on the outside
Note: The rear mag wheels can mounted in 3 vertical positions on the mounting plate: low, mid
and high. Refer to the seat height combination chart on page 24 to determine the appropriate
mounting position for the wheel.
The rear mag wheel can also be mounted horizontally along the base on the side rail.
Hub Cap
Rear Mag Wheel
Handrim
Axle (where hex
screw is located)
Diagram #20
Rear Mag Wheel
Diagram #21
Mag wheel
mounting plate
Diagram #22
Side rail