Specifications

587

Tilt Wheelchair

2) Remove the two seat plugs from the front of the seat frame (one on each side of the seat).

3) Install the two new seat extension plugs and secure them to the seat frame with the ¼” x 1 ¼”

fasteners applied. Make sure the rivet holes on the seat extension plug are on the outside

when the plugs are installed.

4) Install new straps on seat extension plugs. Refer to strap installation instructions on page 33.

5) Adjust the length of the footrest bracket according to the seat depth.

Footrest Bracket Length Adjustment for Seat Depth Extensions

1) Locate the footrest bracket extension rail bolts on both sides

of the chair frame.

2) Using a 3/16” Allen key wrench to the outside of the frame

and a ½” wrench to the inside of the frame, remove the bolts

3) Adjust the extension rail to the desired position and reinsert

the bolts in the appropriate holes through the seat frame.

Tighten bolts.

Seat Depth Extension for Solid Seat Pan

1) Locate the 4 seat pan adjustment bolts that attach

the seat pan to the frame

2) Using a Phillips screwdriver, remove the bolts and

adjust the seat pan to the desired seat depth.

3) Reinsert the bolts in the appropriate corresponding holes

and tighten the bolts

4) For seat depths of 20” or greater with a strapped back,

(19” or 20” with a non strapped back) a larger seat pan

must be used.

5) Adjust the footrest bracket length to accommodate the

seat depth (See instructions above)

Diagram #19

Footrest bracket

extension rail

Adjustment bolts

Diagram #20

Seat pan

adjustment bolt