Specifications

587 Tilt Wheelchair
21
1. Turn the Attachment Tube Handle at the bottom of the pole to loosen and release the
clamp so that the clamps can be attached to the base frame.
2. To attach the clamp to the wheelchair, remove the bolts from the clamp, so it is in two
pieces, and fit it to the wheelchair frame.
3. Place clamps around the designated location on the wheelchair frame, with the
Attachment Stand to the back of the frame.
4. Using two 7/16” wrenches tighten the bolts that will secure the clamps around the
wheelchair frame.
5. Once secured, the IV pole is attached by fitting it back over the Attachment Stand, and
tightened by turning the handle.
4.5 Adjustable Headrest
The headrest for the 587 is very versatile in its adjustability, allowing for a wide variety of
needs to be met. It can be adjusted in height, depth, yaw, pitch and lateral positioning.
The headrest requires a 3/16´Hex (Allen) Key for adjustability. A 3
mm Hex (Allen) Key must be used for the ball joint.
NOTE: After adjusting headrest to it’s desired position, always
ensure it is secured in place.
Diagram #10
Rear View
Requires 3/16”
Hex (Allen) Key
for adjustment
Requires 3 mm Hex
(Allen) Key for ball
joint adjustability