Specifications

587

Tilt Wheelchair

SECTION 4 - WHEELCHAIR OPERATION

4.1 Armrests

Removing & Installing the Armrests

1. Press in front Arm Release Button.

2. Once Arm Release button is engaged, remove Front Frame Insert by swinging arm up.

Once Front Frame Insert is removed, removed Back Frame Insert by pressing in rear

Arm Release Button.

3. To reinstall, push in rear Arm Release Button and insert Back Frame Insert into frame

just behind the rear mag wheel.

4. Push in front Arm Release Button and insert Front Frame Insert into frame

Adjusting the Armrest Height

1. Depress the Arm Height Adjustment Pin toward

the front of the chair

2. Pull up on the arm top to your desired height. Release the pin

and push down until the pin locks with the tube holes.

Note: Do not place fingers directly under arm as this can

cause pinching.

Replacing the Armrest Tops

1. Using a Phillips screwdriver loosen the 2 screws under arm top.

2. Remove Arm Top and place new Arm Top on frame and using

same screwdriver and screw new Arm Tops in place.

Diagram #4

Adjustable

Arm Rests

rm To

Front Frame Insert

Arm Release

Buttons

Back Frame Insert

Arm Height Adjustment

Depressing

Arm Pin