Instruction manual

Page 7
Select Celsius or Fahrenheit
The display on the control panel indicates the temperature set point.
The display may be congured to display in °F or °C. To switch between
modes, press and hold both the “Temperature UP” button and the
“Temperature DOWN” button for two seconds.
Humidity Control
The Proofer may be operated in a dry or humid condition. To create a
humid condition in the Proofer, pour approximately ¼ cup (50ml) of water
into the water tray. DO NOT overll the tray. For best results, warm or hot
tap water may be used.
Prepare for storage
If the Proofer is ON, press the ON/OFF button once to turn the Proofer
off. Ensure that the green POWER light is not on. Remove the lid and rest
it in the rear hinges in an upright position. Unplug power cord from the
wall receptacle and the Proofer.
NOTE: The power cord must be unplugged before folding the Proofer and
closing the lid.
If the Proofer is warm, let it sit with the lid removed until the heating plate
reaches room temperature. Remove the wire rack. Carefully remove the
water tray, dispose of remaining water and set aside. If necessary wipe
surfaces of the Proofer with a damp cloth to remove any water residue.
Make sure the Proofer is dry before folding for storage. Lift the expanding
box section slightly from the front, then fold by pushing gently in on the
sides and folding the unit towards the back. Lower the folded section into
the base. Place the water tray into the front section of the base. Orient
the wire rack with feet up and place it on the base. Remove the power
cord from the Proofer, fold and place on the rear section of the wire rack.
Lower the lid closed and press on the front to ensure that the latch is
engaged.
Power cord
in rear
Rack up-
side down
(feet up)