Instruction manual

Page 6
GENERAL OPERATING
INSTRUCTIONS
Set Up
Open the lid by lifting the front edge of the Proofer. Allow the lid to rest in
a vertical position. Remove the wire rack, power cord and water tray. Lift
the expanding box section from the front edge, fold it open and t into the
base.
Place the water tray into the center of the heating plate. Place the wire
rack into the enclosure with feet down. Lift the lid straight up from the
rear hinges and place onto the top of the expanded box. Lower the lid to
a closed position. Plug the power cord into the Proofer and then into an
appropriate receptacle.
Pre-Heat
For best results, the Proofer should be pre-heated for 5-10 minutes.
Operation
Plug the Proofer in. Press the ON/OFF button once and ensure that
the POWER light is illuminated. Depress the UP or DOWN buttons
to adjust to the desired temperature. Press and hold either the UP or
DOWN button for three seconds to quickly scroll through the temperature
settings.
The HEATING light will illuminate indicating that the heat plate is warming
up. When the Proofer reaches its temperature set point the HEATING
light will go off. It is normal for the HEATING light to ash on and off as
the Proofer maintains its temperature during use.