Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 85
53-1001945-01
show
2
Parameters
ap
Status of adopted access port.
• <1-48> – The index of the access port.
• AA-BB-CC-DD-EE-FF – The MAC address of a access port.
ap-detection-config
Detected AP configuration parameters.
ap-images
Lists the access port images on the switch.
ap-unadopted
Lists unadopted access ports.
approved-aps
Approved APs seen by access port scans.
channel-power
List of available channel and power levels for a radio.
• 11a – Radio is 802.11a.
• indoor – Radio is placed indoors.
• outdoor – Radio is placed outdoors.
• 11b – Radio is 802.11b.
• indoor – Radio is placed indoors.
• outdoor – Radio is placed outdoors.
• 11bg – Radio is 802.11bg.
• indoor – Radio is placed indoors.
• outdoor – Radio is placed outdoors.
config
Wireless configuration parameters.
country-code-list
List of supported country names and 2 letter IS0 3166 codes.
default-ap
Information for default access-port.
hotspot-config <1-32>
WLAN hotspot configuration.
mac-auth-local
List out the mac-auth-local entries.
• <1-1000> – Displays mac-auth-local entry.
mobile-unit
Details of associated mobile unit.
• <1-8192> – Index of mobile unit.
• AA-BB-CC-DD-EE-FF – MAC address of mobile unit.
• association-history <mac adress> – Displays mobile unit history. Enter the
mobile unit MAC address in AA-BB-CC-DD-EE-FF format.
• probe-history ( ) – Displays MU probe-history.
• <1-200> – Index to display probe-logging.
• config-list – List probe history MAC addresses.
• radio <1-4096> – Show mobile units associated with this radio.
• statistics – Mobile unit rf statistics.
• wlan <wlan_range> – Shows mobile units associated to this WLAN.
multicast-packet-limit
Multicast packet limit.
qos-mapping
Quality of Service mappings used for mapping WMM access categories and 802.1p
/ DSCP tags.
• wired-to-wireless – Mappings used when traffic is switched from wired to the
wireless side.
• wireless-to-wired – Mappings used when traffic is switched from wireless to the
wired side.