Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR CLI Reference Guide 559
53-1001945-01
Chapter
21RTLS Instance
In this chapter
•RTLS Config Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 559
Use the
(config-rtls) instance to configure Real Time Location System (RTLS) parameters.
To navigate to this instance, use the command
RFSwitch(config)#rtls
RFSwitch(config-rtls)#
RTLS Config Commands
The following table summarizes config-rtls commands:
TABLE 18 RTLS Configuration commands summary
Command Description Ref.
aeroscout Configures aeroscout parameters page 560
ap Configures AP specific RTLS parameters page 561
clrscr Clears display window page 563
end Ends the current mode and moves to EXEC mode page 564
exit Ends current mode and moves to the previous mode page 565
help Description of the interactive help system page 566
ekahau Configures ekahau parameters page 567
no Negates a command or sets its defaults page 568
service Invokes service commands to troubleshoot or debug
(config-rtls) instance configurations
page 571
show Displays the running system information page 573
site Configures site parameters page 575
sole Configures Smart Opportunistic Location Engine (SOLE)
parameters
page 576
switch Configures switch parameters page 577