Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 533
53-1001945-01
Wireless Configuration Commands
20
sensor
Wireless Configuration Commands
Use this command to configure Wireless Intrusion Protection System parameters.
Syntax
sensor (default-config) (wips-server-ip {primary|secondary})
Parameters
Example
FS7000(config-wireless)#sensor default-config wips-server-ip primary 1.0.2.3
RFS7000(config-wireless)#
default-config
The default configuration sent to sensors when they are configured.
wips-server-ip
{primary|secondary}
Specifies IP addresses of the WIPS server.
• primary <A.B.C.D> – Specifies the primary IP address of the WIPS server.
• secondary <A.B.C.D> – Specifies the secondary IP address of the WIPS server.
• A.B.C.D – IP address in A.B.C.D format.