Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 521
53-1001945-01
Wireless Configuration Commands
20
no
Wireless Configuration Commands
Use this command to negate a command or set its defaults.
Syntax
no[aap|admission-control|adopt-unconf-radio|adoption-pref-id|ap|ap-containment|ap
-detection|ap-ip|ap-standby-attempts-threshold ap-timeout|auto-select-channels
ap-udp-port|broadcast-tx-speed|cluster-master-support|country-code|debug|dhcp-one
-portal-forward |dhcp-sniff-state|
fix-windows-dhcp fix-broadcast-dhcp-rsp
|hotspot|load-balance|mac-auth-local|manual-wlan-mapping|mobile-unit|
mobility|multicast-packet-limit|multicast-throttle-watermarks|nas-id|nas-port-id|
non-preferred-ap-attempts-threshold|proxy-arp|
qos-mapping|radio|self-heal|sensor|service|smart-scan-channels|wips|wlan|wlan-bw-
allocation]
Parameters
The
no command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Example
RFS7000(config-wireless)#no mobility enable
RFS7000(config-wireless)#