Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 517
53-1001945-01
Wireless Configuration Commands
20
multicast-throttle-watermarks
Wireless Configuration Commands
Use this command to configure watermarks for handling bursts of broadcast/multicast frames.
Syntax
multicast-throttle-watermarks (low)<0-100> (high) <0-100>
Parameters
Example
RFS7000(config-wireless)#multicast-throttle-watermarks low 10 high 20
RFS7000(config-wireless)#
low <0-100>
Configures the low water-mark. If the percentage of free packets in the system is
lower than this threshold, the incoming frame will be dropped.
high <0-100>
Configure the high water-mark. If the percentage of free packets in the system is
between the low water-mark and this value, the packet is subjected to a
random-early-drop. If free packets are greater than this value, the packet is
processed.