Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
516 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
multicast-packet-limit
Wireless Configuration Commands
Use this command to a configure multicast packet limit per second for a VLAN.
Syntax
multicast-packet-limit <0-128> (<1-4094>|<vlan range>)
Parameters
Example
RFS7000(config-wireless)#multicast-packet-limit 120 50
RFS7000(config-wireless)#multicast-packet-limit
RFS7000(config-wireless)#multicast-packet-limit 120 1,10,25
RFS7000(config-wireless)#multicast-packet-limit
<0-128>
[<1-4094 | <vlan range>]
Multicast packet limit per second.
• <1-4094> – Single VLAN ID (1-4094) that the new limit applies to.
• <vlan range> – A list (1,3,7) or range (3-7 ) of VLAN IDs.