Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 515
53-1001945-01
Wireless Configuration Commands
20
mobility
Wireless Configuration Commands
Use this command to configure mobility parameters
Syntax
mobility(enable|local-address|max-roam-period|peer)
mobility local-address (<IP AddressA.B.C.D)>
mobility max-roam-period<1-300>
mobililty peer <(IP AddressA.B.C.D>)
Parameters
Example
RFS7000(config-wireless)#mobility enable
RFS7000(config-wireless)#
RFS7000(config-wireless)#mobility local-address 12.12.12.1
RFS7000(config-wireless)#
RFS7000(config-wireless)#mobility max-roam-period 10
RFS7000(config-wireless)#
RFS7000(config-wireless)#mobility peer 157.208.235.108
RFS7000(config-wireless)#
enable
Enables mobility globally.
local-address
<IP addressA.B.C.D>
Sets the local address for mobility.
• A.B.C.D – IP Address of A.B.C.D format.
max-roam-period
<1-300>
Sets the maximum roam period for a mobile unit (in seconds).
peer <Peer IP
AddressA.B.C.D>
Adds a peer to this mobility region.
• A.B.C.D – IP address of the Peer.