Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 497
53-1001945-01
Wireless Configuration Commands
20
broadcast-tx-speed
Wireless Configuration Commands
Use this command to configure the rate broadcast and multicast traffic transmitted between the
switch and mobile units.
Syntax
broadcast-tx-speed(range|throughput)
Parameters
Example
RFS7000(config-wireless)#broadcast-tx-speed range
RFS7000(config-wireless)#
RFS7000(config-wireless)#broadcast-tx-speed throughput
RFS7000(config-wireless)#
range
Uses the lowest basic rate. Provides the maximum range.
throughput
Uses the highest basic rate. Provides the maximum throughput (default).