Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
496 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
ap-udp-port
Wireless Configuration Commands
Use this command to configure the UDP port for layer 3 AP adoption. Configure the DHCP server
supporting the AP’s with the same parameter.
Syntax
ap-udp-port <1-65535>
Parameters
Example
RFS7000(config-wireless)#ap-udp-port 10
RFS7000(config-wireless)#
<1-65535> The port number used for layer 3 AP adoption.