Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
494 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Wireless Configuration Commands
20
ap-timeout
Wireless Configuration Commands
Use this command to change the default inactivity timeout period for access-port(s).
Syntax
ap-timeout <LIST> <40-180>
Parameters
Example
RFS7000(config-wireless)#ap-timeout 1 40
RFS7000(config-wireless)#
LIST <40-180>
An access-ports identified by a single MAC address or by a list of indices. Use show
wireless ap
to view the AP’s adopted by the MU and their IP addresses.
Note If multiple access-ports are specified, each gets a unique
IP address.