Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR CLI Reference Guide 467
53-1001945-01
RADIUS Configuration Commands
19
service
group
Use this command to invoke RADIUS service commands. This command is used to enable the
RADIUS Server. A service RADIUS restart is executed only from the
config mode.
Syntax
service (show) (cli)
Parameters
Example
RFS7000(config-radsrv-group)#service show cli
Radius user group configuration mode:
+-clrscr [clrscr]
+-do
+-LINE [do LINE]
+-end [end]
+-exit [exit]
+-group
+-WORD [group WORD]
+-guest-group
+-enable [guest-group enable]
+-help [help]
+-no
+-policy
+-day [no policy day]
+-time [no policy time]
+-vlan [no policy vlan]
+-wlan
+-<1-256> [no policy wlan (all|.<1-256>) ]
.................................................................................
.................................................................................
.................................................................................
RFS7000(config-radsrv-group)#
show (cli)
Shows running system information.