Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 437
53-1001945-01
Chapter
18DHCP Class Instance
In this chapter
•DHCP Server Class Config Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . 437
Use
(config)#ip dhcp class <class name> to enter (config-dhcpclass)instance. Use this
instance to configure the DHCP user class. The switch supports a maximum of 8 user classes per
DHCP class.
Also refer ip on page 191 and DHCP Server Instance on page 401 for other DHCP related
configurations.
DHCP Server Class Config Commands
Table 18.4 DHCP Server Class config commands
Command Description Ref.
clrscr Clears the display screen. page 438
end Ends the current mode and moves to the EXEC mode. page 439
exit Ends the current mode and moves to the previous mode. page 440
help Displays the interactive help system. page 441
multiple-user-class Enables multiple user class option. page 442
no Negates a command or set its defaults. page 443
option Configures DHCP Server options. page 444
service Displays service Commands. page 445
show Displays running system information. page 446