Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR CLI Reference Guide 433
53-1001945-01
DHCP Config Commands
17
update
DHCP Config Commands
Use this command to control the usage of the DDNS service.
Syntax
update (dns)(override)
Parameters
Usage Guidelines
A DHCP client cannot perform updates for RR’s A, TXT and PTR. Use
update (dns) (override)
to enable the internal DHCP Server to send DDNS updates for resource records (RR’s) A, TXT and
PTR. The DHCP Server can always override the client, even if the client is configured to perform the
updates.
In the network pool of DHCP Server, FQDN is configured asa DDNS domain name. This is used
internally in DHCP packets between the switch’s DHCP Server and the DNS server.
Example
RFS7000(config-dhcp)#update dns override
RFS7000(config-dhcp)#
update (dns) (override)
Controls the usage of the DDNS service.
• (dns) – Dynamic DNS Configuration.
• (override) – Enables Dynamic Updates by an onboard DHCP Server.