Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
428 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
no
DHCP Config Commands
Use this command to negate a command or set defaults.
Syntax
no
[address|bootfile|class|client-identifier|client-name|ddns|default-router|dns-ser
ver|domain-name|hardware-address|host|lease|netbios-name-server|netbios-node-type
|network|next-server|option|update]
Parameters
The
no command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
The pool has only one bootfile and hence the
<filename > is not required when using the [no]
command. To remove a bootfile use
no bootfile command only.
Example
RFS7000(config)#no ip dhcp pool hotpool
RFS7000(config)#
RFS7000(config)#no ip dhcp pool test
RFS7000(config)#
RFS7000(config-dhcp)#no update dns
RFS7000(config-dhcp)#
RFS7000(config-dhcp)#no bootfile
RFS7000(config-dhcp)#