Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR CLI Reference Guide 427
53-1001945-01
DHCP Config Commands
17
next-server
DHCP Config Commands
Use this command to configure the IP address of the next server in the boot process.
Syntax
next-server <IP addressA.B.C.D>
Parameters
Example
RFS7000(config-dhcp)#next-server 2.2.2.22
RFS7000(config-dhcp)#
next-server <IP
addressA.B.C.D>
Defines the next server in the boot process.
• <IP address> – Server's IP address.