Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
426 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
network
DHCP Config Commands
Use this command to configure the network pool’s IP address. This maps the current DHCP pool
with the specific network.
Syntax
network [A.B.C.D|A.B.C.D/M]
Parameters
Usage Guidelines
Ensure a VLAN interface with specific network /subnet exists on the switch before mapping the
DHCP pool to a particular network.
Example
RFS7000(config-dhcp)#network 2.2.2.0/24
RFS7000(config-dhcp)#
network
[A.B.C.D|A.B.C.D/M]
Network number and mask.
• A.B.C.D – Network number in dotted decimal format.
• A.B.C.D/M – Network number and mask.