Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
422 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
host
DHCP Config Commands
Use this command to configure a fixed IP address for the host in dotted decimal format. Use the
no
host
command to remove the host from the DHCP pool.
Syntax
host <IP address>
Parameters
Usage Guidelines
The DHCP host pool (used to manually assign specify IP address based on hardware address/client
identifier), configuration must contain a host IP address, client name and hardware address/client
identifier.
The host IP address must belong to subnet on the switch. There must be a DHCP network pool
corresponding to that host IP address. There is no limit on the number of manual binding’s but you
can configure only one manual binding per host pool.
Example
RFS7000(config-dhcp)#host 2.2.2.111
RFS7000(config-dhcp)#
host <IP address>
Fixed address for host.
• IP address – IP address in dotted decimal format.