Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
420 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
hardware-address
DHCP Config Commands
Use this command to reserve an IP address (manually) based on a DHCP client’s hardware
address. Use the
no hardware-address command to remove this from the DHCP pool.
Syntax
hardware-address [XX-XX-XX-XX-XX-XX | XX:XX:XX:XX:XX:XX]
Parameters
Usage Guidelines
This command accepts only hexadecimal values.
Example
RFS7000(config-dhcp)#hardware-address 00:01:23:45:32:22
RFS7000(config-dhcp)#
hardware-address
[XX-XX-XX-XX-XX-XX |
XX:XX:XX:XX:XX:XX]
Configures the client’s hardware address.
• XX-XX-XX-XX-XX-XX – Dashed-hexadecimal string.
• XX:XX:XX:XX:XX:XX – Dotted-hexadecimal string.