Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
416 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
dns-server
DHCP Config Commands
Use this command to configure the DNS server’s IP address available to the DHCP clients
connected to the pool. Use the
no dns-server command to remove DNS server list.
Syntax
dns-server <ip address1A.B.C.D> <ip address2A.B.C.D> <ip address3A.B.C.D>
.....<ip address8A.B.C.D>
Parameters
Usage Guidelines
For DHCP client’s, the DNS server’s IP address is used to map the host name to IP address. The
DHCP client uses the DNS servers IP address based on the order (sequence) configured.
Example
RFS7000(config-dhcp)#dns-server 2.2.2.222
RFS7000(config-dhcp)#
dns-server <IP
addressA.B.C.D>
Configures the DNS Server’s IP address.
• <IP address>A.B.C.D> – Server's IP address.