Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR CLI Reference Guide 415
53-1001945-01
DHCP Config Commands
17
default-router
DHCP Config Commands
Use this command to configure the default router or gateway IP address for the network pool. To
remove the default router list, use the
no default-router command.
default-router <Router IP address>
Parameters
Usage Guidelines
The IP address of the router should be on the same subnet as the client subnet.
Example
RFS7000(config-dhcp)#default-router 2.2.2.1
RFS7000(config-dhcp)#
default-router
<router IP address>
Specifies the default router IP address for the network pool.
• <router IP address> – Router's IP address.