Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
342 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
mst Config commands
13
instance
mst Config commands
Use this command to associate VLAN(s) with an instance.
Syntax
instance <1-15> vlan <VLAN_ID>
Parameters
Usage Guidelines
MSTP is based on instances. An instance is a group of VLAN’s with a common spanning tree. A
single VLAN cannot be associated with multiple instances.
Switches with same instance - VLAN mapping, revision number and region names creates a region.
Switches in the same region exchange bridge protocol data units (BPDU) with instance record
information.
Example
The example below creates an instance named 10 and maps VLAN 20 to it.
RFS7000(config-mst)#instance 10 vlan 20
RFS7000(config-mst)#
<1-15>
Defines the instance ID to which the VLAN is associated.
vlan <VLAN_ID>
Defines the VLAN ID for its association with an instance.