Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 335
53-1001945-01
Interface Config commands
12
tunnel
Interface Config commands
Use this command to configure protocol-over-protocol tunneling.
Syntax
tunnel(destination|source|ttl)
tunnel destination A.B.C.D
tunnel source A.B.C.D
tunnel ttl
<1-255>
Parameters
Example
RFS7000(config)#interface tunnel 1
RFS7000(config-if)#tunnel destination 172.168.200.20
RFS7000(config-if)#tunnel ttl 33
RFS7000(config)#show interfaces tunnel 1
Interface tunnel1
Hardware Type Tunnel, Interface Mode Layer 3
index=13, metric=1, mtu=1476, (PAL-IF) <UP,POINTOPOINT,RUNNING,NOARP>
Tunnel source 172.168.100.20, destination 172.168.200.20
Tunnel protocol/transport GRE/IP, Tunnel TTL 33
input packets 0, bytes 0, dropped 0, multicast packets 0
input errors 0, length 0, overrun 0, CRC 0, frame 0, fifo 0, missed 0
output packets 0, bytes 0, dropped 0
output errors 0, aborted 0, carrier 0, fifo 0, heartbeat 0, window 0
collisions 0
RFS7000(config)#
destination
Destination of tunnel packets.
• A.B.C.D – Internet Protocol (IP).
source
Source of tunnel packets.
• A.B.C.D – Internet Protocol (IP).
ttl
Sets the time to live interval.
• <1-255> – The time to live (ttl) in seconds.