Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
332 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Interface Config commands
12
static-channel-group
Interface Config commands
Use this command to add an interface to a static channel group.
Syntax
static-channel-group <1-4>
Parameters
Usage Guidelines
This command aggregates individual giga port’s into a single aggregate link to provide a larger
bandwidth. The static channel group is used to provide additional bandwidth in multiples of 1Gbps
on the switch. All MAC layer and higher protocols see only the static channel group (aggregate link)
rather than the individual ports that comprise it.
Example
RFS7000(config-if)#static-channel-group 2
RFS7000(config-if)#
<1-4>
Static channel group to associate the link with.