Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
322 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Interface Config commands
12
mtu
Interface Config commands
Use this command to set the mtu value for a VLAN interface.
NOTE
This command is valid only with a VLAN interface.
Syntax
mtu
<512-1500>
Parameters
Usage Guidelines
All interfaces have a default maximum packet size of 1500 bytes. Use the
mtu command to set the
MTU size of the packets thats travels through the interface.
Example
RFS7000(config)#interface vlan 20
RFS7000(config-if)#mtu 520
RFS7000(config-if)#
<512-1500>
Maximum packet size in bytes. The minimum value is 512 and maximum value is
1500.