Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
304 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
Trustpoint Config commands
11
no
Trustpoint Config commands
Use this command to negate a command or set defaults.
Syntax
no [company-name|email|fqdn|ip-address|subject-name]
Parameters
Example
RFS7000(config-trustpoint)#no ip-address
RFS7000(config-trustpoint)#
company-name
Negates the configured company name.
email
Negates email address
fqdn
Negates Domain Name Configuration (DNS).
ip-address
Negates Internet Protocol (IP)
subject-name
Negates subject name, which is a collection of required parameters to configure a
trustpoint.
It comprises of common_name, country, state, organization,org name etc.