Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 271
53-1001945-01
Chapter
9Crypto-ipsec Instance
In this chapter
•Crypto IPSec Config Commands. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 271
Use the
crypto ipsec transform-set <transform set name> command to define a
transform configuration for securing data using esp-3des or esp-sha-hmac or other cipher modes.
The transform-set is then assigned to a crypto map using the map’s
set transform-set
command. For more details on the crypto-map transform-set command, see “crypto” on page 183.
Crypto IPSec Config Commands
The following table summarizes the config-crypto-ipsec commands within the Brocade Mobility
RFS7000-GR Controller command line interface
TABLE 6 Crypto IPSec config commands
Command Description Ref.
clrscr Clears the display screen. page 272
end Ends the current mode and moves to the EXEC mode. page 273
exit Ends the current mode and moves to the previous mode. page 274
help Displays the interactive help system. page 275
mode Configures IPSec Transporation Mode. page 276
no Negates a command or set its defaults. page 277
service Displays service commands. page 278
show Show running system information. page 279