Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 261
53-1001945-01
Chapter
8Crypto-peer Instance
In this chapter
•Crypto Peer Config Commands. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 261
Use
crypto isakmp(
peer
)
[IP Address|dn|hostname]
to initiate config-crypto-peer instance.
Crypto Peer Config Commands
The following table summarizes the config-crypto-peer commands within the Brocade Mobility
RFS7000-GR Controller command line interface.
TABLE 5 Crypto Peer config commands
Command Description Ref.
clrscr Clears the display screen. page 262
end Ends the current mode and moves to EXEC mode. page 263
exit Ends the current mode and moves to the previous mode. page 264
help Displays the interactive help system. page 265
no Negates a command or set its defaults. page 266
service Displays service commands. page 267
set Sets the configuration. page 268
show Shows running system information. page 269