Reference Guide (Supporting software release 4.1.0.0-040GR and later) User guide
Table Of Contents
- Table of Contents
- About This Document
- Introduction
- Common Commands
- User Exec Commands
- Privileged Exec Commands
- Global Configuration Commands
- Crypto-isakmp Instance
- Crypto-group Instance
- Crypto-peer Instance
- Crypto-ipsec Instance
- Crypto-map Instance
- Crypto-trustpoint Instance
- Interface Instance
- Spanning tree-mst Instance
- Extended ACL Instance
- Standard ACL Instance
- Extended MAC ACL Instance
- DHCP Server Instance
- DHCP Class Instance
- RADIUS Server Instance
- Wireless Instance
- RTLS Instance
- SOLE Instance
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 233
53-1001945-01
Global Configuration Commands
5
wireless
Global Configuration Commands
Use this command to configure switch wireless parameters. This command leads moves to the
config-wireless instance. For additional information, see Wireless Instance on page 483.
Syntax
wireless
Parameters
None.
Usage Guidelines
The wireless command is used to enter the config-wireless instance. The prompt changes from the
regular
RFS7000(config)# to RFS7000(config-wireless)#.
Example
RFS7000(config)#wireless
RFS7000(config-wireless)#