Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

986 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
14
flow timeout tcp
[close-wait|reset|setup|stateless-fin-or-reset|stateless-general]
<1-32400>
flow timeout tcp established <15-32400>
Example
rfs7000-37FABE(config-rw-policy-test)#flow timeout udp 10000
rfs7000-37FABE(config-rw-policy-test)#flow timeout icmp 16000
rfs7000-37FABE(config-rw-policy-test)#flow timeout other 16000
rfs7000-37FABE(config-rw-policy-test)#flow timeout tcp established 1500
rfs7000-37FABE(config-fw-policy-test)#show context
firewall-policy test
no ip dos tcp-sequence-past-window
flow timeout icmp 16000
flow timeout udp 10000
flow timeout tcp established 1500
flow timeout other 16000
dhcp-offer-convert
dns-snoop entry-timeout 35
rfs7000-37FABE(config-fw-policy-test)#
Related Commands:
ip
firewall-policy
Configures Internet Protocol (IP) components
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
timeout Configures a packet timeout
tcp Configures the timeout for TCP packets
close-wait Configures the closed TCP flow timeout. The default is 10 seconds.
reset Configures the reset TCP flow timeout. The default is 10 seconds.
setup Configures the opening TCP flow timeout. The default is 10 seconds.
stateless-fin-or-reset Configures stateless TCP flow timeout created with the FIN or RESET packets. The default is 10 seconds.
stateless-general Configures the stateless TCP flow timeout. The default is 90 seconds (1m 30 s).
<1-32400> Configures the timeout from 1 - 32400 seconds
timeout Configures the packet timeout
tcp Configures the timeout for TCP packets
established Configures the established TCP flow timeout. The default is 5400 seconds.
<15-32400> Configures the timeout from 15 - 32400 seconds
no Removes session timeout intervals configured for different packet types