Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 985
53-1003098-01
14
Related Commands:
flow
firewall-policy
Defines the session flow timeout interval for different packet types
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
flow [dhcp|timeout]
flow dhcp stateful
flow timeout [icmp|other|tcp|udp]
flow timeout [icmp|other] <1-32400>
flow timeout udp <15-32400>
flow timeout tcp
[close-wait|reset|setup|stateless-fin-or-reset|stateless-general]
<1-32400>
flow timeout tcp established <15-32400>
Parameters
flow dhcp stateful
flow timeout [icmp|other] <1-32400>
flow timeout udp <15-32400>
no Disables a device’s firewall
dhcp Configures DHCP packet flow
stateful Performs a stateful check on DHCP packets. This feature is enabled by default.
timeout Configures a packet timeout
icmp Configures the timeout for ICMP packets. The default is 30 seconds.
other Configures the timeout for packets other than ICPM, TCP, or UDP. The default is 30 seconds.
<1-32400> Configures the timeout from 1 - 32400 seconds
timeout Configures a packet timeout
udp Configures the timeout for UDP packets. The default is 30 seconds.
<15-32400> Configures the timeout from 15 - 32400 seconds