Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 961
53-1003098-01
13
Related Commands:
static-binding-mode commands
static-binding
The following table summarizes static binding configuration mode commands.
bootfile
static-binding-mode commands
The Bootfile command provides a diskless node the path to the image file used while booting up.
Only one file can be configured for each static IP binding.
For more information on the BOOTP protocol with reference to static binding, see bootp.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
bootfile <IMAGE-FILE-PATH>
no Resets values or disables the DHCP policy static binding settings
static-binding-mode
commands
Invokes static binding configuration commands
Command Description Reference
bootfile Assigns a Bootfile name for the DHCP configuration on the network pool page 961
client-name Configures a client name page 962
default-router Configures default router or gateway IP address page 963
dns-server Sets the DNS server’s IP address available to all DHCP clients connected to the DHCP
pool
page 964
domain-name Sets the network pool’s domain name page 965
ip-address Configures a host’s fixed IP address page 965
netbios-name-server Configures a NetBIOS (WINS) name server IP address page 966
netbios-node-type Defines the NetBIOS node type page 967
next-server Specifies the next server used in the boot process page 968
no Negates a command or sets its default page 969
option Configures raw DHCP options page 971
respond-via-unicast Sends a DHCP offer and DHCP Ack as unicast messages page 972
static-route Adds static routes installed on DHCP clients page 973