Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 937
53-1003098-01
13
excluded-address Prevent DHCP Server from assigning certain addresses
lease Address lease time
netbios-name-server NetBIOS (WINS) name servers
netbios-node-type NetBIOS node type
network Network on which DHCP server will be deployed
next-server Next server in boot process
no Negate a command or set its defaults
option Raw DHCP options
respond-via-unicast Send DHCP offer and DHCP Ack as unicast messages
static-binding Configure static address bindings
static-route Add static routes to be installed on dhcp clients
update Control the usage of DDNS service
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-dhcp-policy-test-pool-pool1)#
Related Commands:
dhcp-pool-mode commands
dhcp-pool
Configures the DHCP pool parameters
The following table summarizes DHCP pool configuration commands.
no Removes a specified DHCP address pool
Command Description Reference
address Specifies a range of addresses for a DHCP address pool page 938
bootfile Assigns a bootfile name. The bootfile name can contain letters, numbers, dots and
hyphens. Consecutive dots and hyphens are not permitted.
page 939
ddns Configures dynamic DNS parameters page 940
default-router Configures a default router or gateway IP address for the network pool page 941
dns-server Sets a DNS server’s IP address available to all DHCP clients connected to the DHCP
pool
page 942
domain-name Sets the domain name for the network pool page 943
excluded-address Prevents a DHCP server from assigning certain addresses to the DHCP pool page 944
lease Sets a valid lease for the IP address used by DHCP clients in the DHCP pool page 946
netbios-name-server Configures a NetBIOS (WINS) name server’s IP address page 947
netbios-node-type Defines the NetBIOS node type page 948
network Configures the network on which the DHCP server is deployed page 949