Reference Guide (Supporting software release 5.5.0.0 and later) Owner manual

Brocade Mobility RFS Controller CLI Reference Guide 935
53-1003098-01
13
Related Commands:
option
dhcp-class-mode commands
Configures DHCP user class options for this DHCP user class policy
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
option user-class <VALUE>
Parameters
option user-class <VALUE>
Example
rfs7000-37FABE(config-dhcp-policy-test-class-class1)#option user-class hex
rfs7000-37FABE(config-dhcp-policy-test-class-dhcpclass1)#show context
dhcp-class dhcpclass1
option user-class hex
multiple-user-class
rfs7000-37FABE(config-dhcp-policy-test-class-dhcpclass1)#
Related Commands:
dhcp-pool
dhcp-server-policy
The DHCP pool command creates and manages a pool of IP addresses. These IP addresses are
assigned to devices using the DHCP protocol. IP addresses have to be unique for each device in the
network. Since IP addresses are finite, DHCP ensures that every device, in the network, is issued a
unique IP address by tracking the issue, release, and reissue of IP addresses.
The DHCP pool command configures a finite set of IP addresses that can be assigned whenever a
device joins a network.
multiple-user-class Enables or disables multiple user class option for this DHCP user class policy
option Configures DHCP user class options for this DHCP user class policy
user-class <VALUE> Configures DHCP user class options
• <VALUE> – Specify the DHCP user class option’s ASCII value.
no Removes the configured DHCP user class option